MY 00RX 300 vibrates at 65 MPH
#1
Rookie
Thread Starter
Join Date: Jan 2008
Location: ca
Posts: 74
Likes: 0
Received 0 Likes
on
0 Posts
MY 00RX 300 vibrates at 65 MPH
when i purchased my car it came with 20" wheels and tires and at 60+ heavy vibration.. So i purchased stock 16" and now i have little vibration still.
The 16" i had them balance the wheels + tires so i know its not the 16" wheels
Could it be my alignment?
any help is appreciated.
THX
The 16" i had them balance the wheels + tires so i know its not the 16" wheels
Could it be my alignment?
any help is appreciated.
THX
#3
Moderator
Rim size has almost nothing to do with it ... other than larger rims require more delicate balancing. I have heard that Hunter machine gives better results.
Salim
Salim
#5
Moderator
This is again one of controversial issue. I am of the opinion that it is due to lack of proper balancing. Some say that lack of alignment causes shakes (my view is only if the things are loose).
I would suggest take the RX back to the shop who did the balance and if needed take the tech for a test drive.
Salim
I would suggest take the RX back to the shop who did the balance and if needed take the tech for a test drive.
Salim
#6
Lexus Champion
If your wheels are not torqed properly/unevenly it will do that (I have first hand experience on this) try removing each wheel,installing nice and evenly,dont over tighten them, and see if that was your problem.In other words,If they started tightening your wheels by torqing down on the first lug nut,etc.then your wheel is installed unevenly.
Last edited by lexus114; 01-23-08 at 06:22 AM. Reason: not finished
#7
Misalignment usually causes straying and travel of the steering. If the vibration is from the wheels and you feel it in steering wheels, I'd say it's more likely the balance. Make sure you get all four wheels re-balanced and tell the shop that did it the problem.
Trending Topics
#9
Moderator
Did you take the tech for a ride afterwards?
Was any work done on the drive half shafts/rotors etc that can make them off rotational balance?
Salim
Was any work done on the drive half shafts/rotors etc that can make them off rotational balance?
Salim
Thread
Thread Starter
Forum
Replies
Last Post