lexsg

My battery died and was replaced with a new one. After that, the passenger window cannot be controlled by the driver's side, and worse still, the rear windows doesn't work at all.

Is there a reset function I could use, or did a fuse blow? Please help! Thanks.

HarrierAWD

Make sure the "child-proof" button isn't depressed. It is the small button next to driver's side lock button. That'd lock out all windows except driver's side.

lexsg

Thank you sir. Confirmed the button is not depressed at all.

rl9905

Here this is from the Manual:

If the battery is disconnected or run down

The power windows may not operate automaticaly and the jam protection function will not function correctly after you reconnect, replace or recharge the battery. At this time, the indicator lights of the switches will flash. In any of these cases, you should normalize the power windows

1. Push down the power window switches of each door and lower the windows halfway.

2. Pull the switches until the windows close and hold the switches for a second.

________________________________

The moon roof may not operate automaticlly and the jam protection functon will not function correctly after you reconnect, replace or recharge the battery. In any of these cases, you should normalize the moon roof.

To normalize the moon roof, push and hold the switch on the "TILT UP" side until the moon roof tilts all the way up and then tilts down a little automatically.

lexsg

Thanks rl9905. I tried it, I it worked! Really appreciate your initiative.

Fern

Great work Rl9905

I too learned something with your tip..

rl9905

No problem, I'm glad you guys got your problems solved and are now happy.

headcrash

This worked for me as well, BIG THANK YOU!

thepaulkim

thanks!! worked for me as well.

salimshah

Another invaluable tip ,,,

Read the manual.

Salim

peteharvey

This just happened to my IS250.
Thank God for this forum.

Does anyone know why this phenomenon occurs?
Because I changed my ES300 battery a few months ago, and this never happened to the ES300's power windows...

asciarra21

Just replaced the original battery in my 2007 and had same window issue. But with the great info it was quickly resolved.

Thank You Very Much

Briand_OH

IMO this default -might- do two things:

Get some service $ for dealers and perhaps CYA for legal problems from sue-happy idiots?

salimshah

There is a technical reason ... With power windows and single flick (and sun-roof) one has to have a pinch protection ... the motor should back-up on seeing a resistance ... childs hand in the way etc.

The memorized limit is lost on the removal of +12v. So the system starts out with minimum settings.

Salim

ozarshad

After replacing the battery on my Lexus RX-330 i had the same issue which is solved following the instruction from rl9905. Many thanks.