OEM JDM Side Markers RX350
#1
Driver
Thread Starter
OEM JDM Side Markers RX350
Do all Toyota/Lexus models (fender side markers) share the same measurement where to center the hole on the fender? Found some information on here that it would be 16.5 in up and 3 in left, Are these factory Specs? Thanks in advance.
#3
I did my side repeaters and I just eyeballed it looking at Japan issued RX's.
Here's my post of a DIY:
https://www.clublexus.com/forums/rx-...or-the-rx.html
Here's my post of a DIY:
https://www.clublexus.com/forums/rx-...or-the-rx.html
The following users liked this post:
exaktoh (03-16-17)
#4
Driver
Thread Starter
Looks awesome! Thanks for sharing. This route can get expensive with the oem jdm parts but it's the only way to go. I had this done on my EG6 (94 Civic Si) years back but paid a shop to install while referencing some measurements I've acquired from a forum. Will be checking back on your past posts for reference with this RX project. Thanks again!
Thread
Thread Starter
Forum
Replies
Last Post