Opinion on these parts for brake pads/rotors - Club Lexus Forums


Opinion on these parts for brake pads/rotors

Reply
 
 
 
Thread Tools Search this Thread
Old 07-11-14, 06:20 PM   #1
Stemmer
Driver
Thread Starter
 
Join Date: Jun 2011
Location: MD
Posts: 155
Default Opinion on these parts for brake pads/rotors

I'm close to needing new pads and I cheaped out on rotors last time buying no-name rotors that ended up needing to be machined after I had them installed with new pads. Since then I put on another set of pads and machined them again. I'm thinking it''s safer to get name brand rotors and pads installed rather than machining the cheap rotors a third time. I was quoted $1,400 from Lexus for pads/rotors and "about" $900 to $950 from Toyota. Insanity, especially Lexus.

I spoke with Advance Auto and an indy shop. The shop will charge $250 labor to install all pads/rotors and Advance recommended Wearever Brake Rotors and Wearever Platinum Premium Ceramic Pads. Total parts after on-line discount is $214 bringing the total to $464 instead of $1,400 or about $950. Seems like a no-brainer but I'm looking for feedback on these parts instead of oem. Am I missing anything? These rotors say they don't need machining with initial installation.

Also I figure I may as well have a brake flush performed at the same time. Advance has a 32 ounce Wearever Gold Brake Fluid. Acceptable or is there a needed Toyota oem and is that enough fluid? Thanks in advance for any advice/response.
Stemmer is offline   Reply With Quote
Old 07-11-14, 06:40 PM   #2
carguy07
Lexus Champion
 
carguy07's Avatar
 
Join Date: Nov 2005
Location: OH
Posts: 1,747
Default

I have had good luck with Advance Auto rotors for quite a while. Have not used their pads though. I have used ATE Blue and Prestone Dot3 with no issues so far, 32 ounces is plenty for a routine flush.
carguy07 is offline   Reply With Quote
Old 07-11-14, 07:40 PM   #3
salimshah
Moderator
 
Join Date: Apr 2001
Location: Austin, TX
Posts: 9,619
Default

Rear rotor+drum and parking brake shoes are a bit hard to replace. The front rotors, front and back pads are extremely easy. Just pay for the parts and DIY.

Salim
salimshah is offline   Reply With Quote
Old 07-11-14, 07:49 PM   #4
Stemmer
Driver
Thread Starter
 
Join Date: Jun 2011
Location: MD
Posts: 155
Default

Thanks for both replies. I will proceed as set forth. And Salim, that's for the suggestion but my DIY ends at engine and cabin filters and pumping out the PSF reservoir. I'm the least handy person around.
Stemmer is offline   Reply With Quote
Old 07-12-14, 10:28 AM   #5
salimshah
Moderator
 
Join Date: Apr 2001
Location: Austin, TX
Posts: 9,619
Default

All you need to do is remove the wheel.
Remove 2 bolts that hold the caliper assembly.
Hang the caliper assembly with coat hanger wire or equivalent.
Remove the rotor, if it has not fallen off by now.
Place the new rotor
Place the caliper assembly and instal the 2 bolts.
You are done with the rotor

Remove 1 long pin bolt.
Swing away the caliper.
Pads would have fallen off by now
suck out some of the brake fluid from master cylinder if it is full
Use a C clamp to squeeze the piston back in the caliper.
clean and lightly grease the (with the brake grease) the shims.
Install the new pads.
Swing the caliper on the rotor
Instal the long pin bolt.
Pads are done

Instal the wheel

You are done.

Salim
salimshah is offline   Reply With Quote
Old 07-12-14, 04:28 PM   #6
fastnoypi
Lexus Test Driver
 
Join Date: Nov 2009
Location: NJ
Posts: 1,211
Default

please write a review of the Platinum pads if you choose to purchase them. The Wearever Gold that have been around have had occasional reviews of brake squeal after a few thousand miles of wear.

Of course with these internet reviews, you cannot be 100% certain if there was an install error on the installer's side.
fastnoypi is offline   Reply With Quote
Old 07-13-14, 08:30 AM   #7
mckellyb
Driver
 
mckellyb's Avatar
 
Join Date: Jul 2003
Location: Texas
Posts: 190
Default

Quote:
Originally Posted by salimshah View Post

...suck out some of the brake fluid from master cylinder if it is full...

Salim
Good tip! And afterward, DO NOT ADD FLUID WHEN THE LEVEL DROPS! The 'Brake' light on the dash is an indicator the pads are worn. This really does work, I've verified it on multiple vehicles, not all of them mine.

Quote:
Originally Posted by salimshah View Post

Use a C clamp to squeeze the piston back in the caliper.

Salim
If you don't have a C-clamp, or a pad retractor (an inexpensive piece, though one which does what its name implies, and that's all), you can use a large flat-head screwdriver to push the piston back in, while the caliper and old pads are still bolted into place.

It's a hack way to do it, but I've used it a few times.

In fact, I put rotors/pads on my '05 STS, Friday. Easy-peasy, though it was 105F in the garage, so it about killed me.

The RX300 has O'Reilly (which is the same as Advance, I think) pads and rotors up front after the OEM's warped long past recovery. I've been quite happy with them.

This said, I just put EBC slotted rotors and Redstuff pads on the STS. I think they're going to be amazing!

I'll be thrilled if there is merely less dust, honestly, but just driving around the neighborhood, yesterday, making certain I won't die on my commute, Monday, they have MUCH more 'bite'.
mckellyb is offline   Reply With Quote
Old 07-15-14, 04:54 PM   #8
Z07
Driver
 
Z07's Avatar
 
Join Date: Oct 2013
Location: GA
Posts: 139
Default

From Rockauto:

CENTRIC 10303250 (103.03250) Brake Pad $ 10.91 1 $ 10.91
CENTRIC 10309300 (103.09300) Brake Pad $ 15.14 1 $ 15.14
CENTRIC 11008590 (110.08590) Parking Brake Shoe $ 11.42 1 $ 11.42
CENTRIC 12144080 (121.44080) Rotor $ 15.81 2 $ 31.62
Discount $ -3.45
Shipping Ground $ 20.91
Order Total $ 86.55

Plus front rotors from a local parts store @ $60/pair (these were cheaper to buy locally due to shipping)

I changed the brake fluid as well as normal caliper pin lube etc.

I did this maintenance recently but so far the brakes are great and quiet. Time will tell how well the Centric ceramic pads hold up.

$146 all in for parts.

EDIT: Also a great time to rotate tires and inspect spare and jack.

Last edited by Z07; 07-15-14 at 04:59 PM.
Z07 is offline   Reply With Quote
 
 
Reply

Related Topics
Thread Thread Starter Forum Replies Last Post
Mylparts give defective parts richard203 GS - 4th Gen (2013-present) 36 12-16-15 09:41 PM
Engine and brake problems wing0 RX - 1st Gen (1999-2003) 2 09-07-15 01:25 PM
Brake pads/rotors EJ255t Suspension and Brakes 25 06-02-15 02:24 PM
shaking steering wheel .. pulsing brake pedal techrep GX - 1st Gen (2004-2009) 10 08-17-14 09:39 AM
RX300 Brake pad direction? jmezo RX - 1st Gen (1999-2003) 2 04-27-05 05:14 AM


Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off

Forum Jump


All times are GMT -7. The time now is 04:47 AM.


Copyright © 2000-2016 Internet Brands, Inc. All Rights Reserved