Sneakerboy

Wow that is beautiful what lip is that? And what are your tire profiles? Any spacers/lowered?

RCFormante

iTrader: (1)

All tuned! Nice improvement mid range, no more CEL, and best of all, speed delimiter!

Davew77

Those TE37's on the front are FACE2, correct? They look good, but I personally wanted more concavity on my front rims. So I went with FACE3 (the same as your rears). Just some info for anyone who might be interested...

DEMIK

iTrader: (18)

rwdryu

Carnevino

Thanks! Lip is by AIMGAIN, no spacers but lowered on RRracing/Penske coils with lots of bits from Figs Engineering.

yooniverse

Got it done with Airrunner System. Ordering Artisan Lip for it now.

RYLITT

Going full kit?

Meraki Autoworks

iTrader: (8)

Nice!

-Josh

yooniverse

Artisan for the front lip (for sure).
I haven't decided yet on the sides and rear (leaning towards the Rowen or Novel for those).

corradoMR2

#FPursuit #DarthNX

Ne1tHeRe

iTrader: (3)

How were you able to get face3 for the fronts and rears? What are the wheel specs?

Davew77

Actually, my rears are FACE4. I was mistaken. But it's an error to the positive side for me (I like concavity).
FACE3

FACE4

You just need a small enough offset to give enough room for concavity to be able to get FACE3. After seeing some pics and reading info about RC F's running 20mm spacers on the front stock rims I decided to pick an offset that would put my stance in the same ballpark. It also allowed enough room that the rims could be FACE3 instead of FACE2. I went with ET35 on a 9-1/2" rim.

Ice350

iTrader: (1)

Now this is a clean looking kit. Flows with the lines and looks as if it could have come from the factory.

bradass

TE errr thang... beautiful!