V8 headers for 3UZ-FE
#1
Driver School Candidate
Thread Starter
V8 headers for 3UZ-FE
Hi!
Finally got my headers done. Made from 304 steel, mandrel bent, 38 mm inner diameter.
O2 sensor needs relocation
Pictures:
http://imgur.com/8UUZZMD
http://imgur.com/Xu5qCwQ
http://imgur.com/w5SQjkg
http://imgur.com/5IVYp5D
http://imgur.com/vubO2KB
http://imgur.com/M1QKeDo
Finally got my headers done. Made from 304 steel, mandrel bent, 38 mm inner diameter.
O2 sensor needs relocation
Pictures:
http://imgur.com/8UUZZMD
http://imgur.com/Xu5qCwQ
http://imgur.com/w5SQjkg
http://imgur.com/5IVYp5D
http://imgur.com/vubO2KB
http://imgur.com/M1QKeDo
Last edited by sHOT1980; 04-28-14 at 08:41 AM. Reason: added new photos
The following users liked this post:
OGGPoodle (07-29-20)
#5
Driver School Candidate
Thread Starter
#7
Lexus Test Driver
iTrader: (16)
Join Date: Dec 2012
Location: FL, UK & Deutschland
Posts: 1,149
Likes: 0
Received 0 Likes
on
0 Posts
Either way, looking forward to how everything turns out OP.
Trending Topics
#8
Driver School Candidate
Thread Starter
Makes sense. Let us know how they fare on the dyno
OBX also makes a set of headers for the 400/430, although there isn't much information available on quality/fitment since most people end up going PPE since the quality and gains are proven; not to mention they're the only company that makes separate sets for LHD/RHD cars.
Either way, looking forward to how everything turns out OP.
OBX also makes a set of headers for the 400/430, although there isn't much information available on quality/fitment since most people end up going PPE since the quality and gains are proven; not to mention they're the only company that makes separate sets for LHD/RHD cars.
Either way, looking forward to how everything turns out OP.
I will install these headers with very qualified guy who weld it, so it's no problem to make some correction, if needed.
At the end of May I hope I will have headers on car
regards
#9
Driver School Candidate
Hi!
Finally got my headers done. Made from 304 steel, mandrel bent, 38 mm inner diameter.
O2 sensor needs relocation
Pictures:
http://imgur.com/8UUZZMD
http://imgur.com/Xu5qCwQ
http://imgur.com/w5SQjkg
http://imgur.com/5IVYp5D
http://imgur.com/vubO2KB
http://imgur.com/M1QKeDo
Finally got my headers done. Made from 304 steel, mandrel bent, 38 mm inner diameter.
O2 sensor needs relocation
Pictures:
http://imgur.com/8UUZZMD
http://imgur.com/Xu5qCwQ
http://imgur.com/w5SQjkg
http://imgur.com/5IVYp5D
http://imgur.com/vubO2KB
http://imgur.com/M1QKeDo
#11
Driver School Candidate
Thread Starter
Got email notification from this thread LOL
Car sold 5 years ago.
It was fabricated by hand, engine out of the car. Car was beautiful with headers, pulls much stronger. No videos (((
Best regards
Car sold 5 years ago.
It was fabricated by hand, engine out of the car. Car was beautiful with headers, pulls much stronger. No videos (((
Best regards
Thread
Thread Starter
Forum
Replies
Last Post