MY 01 GS300 Going Manual Now!
#1
Lead Lap
Thread Starter
MY 01 GS300 Going Manual Now!
My GS300 is getting the next round of mods, I installed the GTE bottom end in my garage along with the intercooler, meth, PTE74mm turbo, Supra headgasket, valve body and some 440cc injectors with a Walbro and a fuel pressure regulator. The 440's were pretty much all the stock GS300 ECU can handle with the MAP ECU, although it was fun it was certainly not enough. I picked up a Haltech from Kean and was referred to Rick @ Speedtech for the install by ZGAD. Initally I was just planning on doing the Haltech but that turned into removing the cams and machining / installing GTE Cams, reworking the head, and going with the R154 to handle the extra power. I thought about going built auto but those stock built auto's break all the time plus for about the same money I could go R154, down the road I can easily upgrade to V160 too. I'm pleased to post up these photos, it was a real bear of a job getting the pedal in / clutch master installed / pedal box installed but Rick pulled it off, Ricks a full time NASA engineer and after seeing some of his custom work at his part time shop I knew this was the guy to pull of one of the only manual GS300's in the country. We have a bit more to go, make a custom intake manifold, make the IC pipes, install the 1000cc injectors and twin Walbro's, tuning, along with customize / extend the shifter position to fit the GS but this should be wrapped up this month!
#2
Lexus Fanatic
iTrader: (1)
Nice, I think I saw you posting something about a tranny swap over on My.IS. If you get it all completed could you possibly provide some info on all the parts needed? Also what kinda fabrication did you have to do to get that clutch pedal in there? I'm going to boost my car to around the 800-1000hp level eventually so I will need to throw in the 6 speed manual V160 at those power levels.
#4
Lead Lap
Thread Starter
The same parts list found on the IS300.net. I used all 01 IS300 cutch parts, the hard part was trimming, welding, and making the IS300 Pedal box / pedal bracket to fit. I didn't do it but Rick @ Speedtech in Merrit Island FL pulled it off for me after messing with it for days under the dash. It was a real PITA to make fit. This is by far the hardest part of converting to manual. Also from what I read online, up until this point it seemed to me everyone in the know about this job said you had to use a remote clutch master cylinder as the firewall is contoured, the only manual GS300's out there had a remote master from what I've seen. This goes to show you you can use all Lexus parts to make this look like factory!
A few more pics of the outside, a bit blurry
A few more pics of the outside, a bit blurry
Last edited by adamgamz; 02-15-08 at 07:39 AM.
Trending Topics
#8
Lead Lap
Thread Starter
Thanks guys, I really wanted to see what I can do with the stock 2JZGE motor too. really no point in wiring, replace the harness, block, crank, head, etc... just swap the pistons / rods and go. I probably saved a good 3K going that route over the GTE with that labor an all.
#12
Hacked CL to become a Mod
what the HELL is that pedal on the left ???
haha nice one...definitely a rare GS
is that an HID retrofit i see?
haha nice one...definitely a rare GS
is that an HID retrofit i see?
Last edited by Kaydee; 02-15-08 at 05:33 PM.