Closed loop tuning - HELP!
#1
Pole Position
Thread Starter
Join Date: Oct 2002
Location: Texas
Posts: 207
Likes: 0
Received 0 Likes
on
0 Posts
Closed loop tuning - HELP!
Ok, so i have 42.5 lb/hr injectors ( approx 412cc), an SC400 MAF, and an S-AFC. I dont have a wideband setup yet, all i have is the lil autometer a/f guage. And an EGT.
I am going to take it to get dyno tuned, but i was wondering if there is any way to tune the low end at all? I am running really rich because i shoot out a black smoke between shifts, (more rpms= more smoke). .....Even though i have no cats, i figured it wouldnt have so much smoke and stink so bad.
Can the wideband on the dyno help tune the low end too? What are my options besides going vpc, or AEM. I am going to go AEM later, but i want to tune as good as i can with the S-AFC if possible.
how to tune in closed loop? is it possible a little?
-Derek
I am going to take it to get dyno tuned, but i was wondering if there is any way to tune the low end at all? I am running really rich because i shoot out a black smoke between shifts, (more rpms= more smoke). .....Even though i have no cats, i figured it wouldnt have so much smoke and stink so bad.
Can the wideband on the dyno help tune the low end too? What are my options besides going vpc, or AEM. I am going to go AEM later, but i want to tune as good as i can with the S-AFC if possible.
how to tune in closed loop? is it possible a little?
-Derek
Thread
Thread Starter
Forum
Replies
Last Post