Auto to Manual
#1
Rookie
Thread Starter
Join Date: May 2003
Location: California
Posts: 94
Likes: 0
Received 0 Likes
on
0 Posts
Auto to Manual
I know this has probably been asked before but I searched and could find anything good. But what is the exact list of parts needed to convert an SC300 from Auto to 5spd. Thanks
#2
Lead Lap
iTrader: (6)
Hey SDJZZ31 are you from San Diego? If so check out All Toyota/Lexus they have a junked 92-94 sc300 5 speed with everything you would need for a 5 speed conversion minus the tranny. They're quite expensive though I would rather buy a sc that was 5 speed and save some money.
Last edited by Deceptik1; 06-14-03 at 12:43 PM.
#3
Rookie
Thread Starter
Join Date: May 2003
Location: California
Posts: 94
Likes: 0
Received 0 Likes
on
0 Posts
I wish I had just waited to find a 5 spd. I needed a car quick when I bought it and I had already searched for 5spd for a couple weeks and couldn't find any.
#4
Driver School Candidate
Join Date: Jun 2003
Location: International
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
i dunno about USA
but the problem with converting soarers to manual in australia/japan is the lack of interior bits to suit, such as centre console, clutch pedal set up, etc.
but the problem with converting soarers to manual in australia/japan is the lack of interior bits to suit, such as centre console, clutch pedal set up, etc.
#6
If I have the engine, transmission, rear end, driveshaft, wiring harness, and ecu, would you want it? All those parts have less than 60k miles on it and it's a '95 (OBD1). PM if interested.
Last edited by BoostAdict; 06-22-03 at 11:52 PM.
Thread
Thread Starter
Forum
Replies
Last Post
2jzinsider
SC400 / 300 Classifieds
6
02-13-13 06:09 AM