Dyno results from today
#1
Lead Lap
Thread Starter
Dyno results from today
Just wanted to post up some dyno numbers my car put down at SP today.
Two hp runs I netted 417rwhp and 418rwhp at 1.2 bar on 100 octane.
I was more please with my rwtq number of 442.2
Attached is my dyno sheet. Sorry rpms are a bit off due to dyno calibration. We're not sure what happened there. Either way, I'm very pleased with the power!
Mods:
2jzgte (US spec)
K&N filter
RMM downpipe
HKS Super Dragger exhaust
Blitz boost controller
ADFX fmic
Here is the hp dyno sheet
https://www.clublexus.com/gallery/da...cn1087-med.jpg
I was also able to do a 1/4mile pull which is will say is VERY weird to do on a dyno, only because your inside of a shop and it just doesn't seem natural to get on the car as if you were at the strip. It was pretty cool though. Spinning 1st gear and part of second on the rollers, I really could have gotten a on it a bit harder . The top end doesn't seem to be the same as when my old supra was bpu+. I had to shift into 5th on the W58 and I just don't think the gearing is great for the 1/4. My trap was 113mph, when with a 6spd, it's probably going to be closer to 117 or so. Eitherway, it ran a 13.1 @113mph with a 2.35 60ft
Here is the 1/4 dyno sheet
https://www.clublexus.com/gallery/da...cn1089-med.jpg
Chris
93 SC300TT
Two hp runs I netted 417rwhp and 418rwhp at 1.2 bar on 100 octane.
I was more please with my rwtq number of 442.2
Attached is my dyno sheet. Sorry rpms are a bit off due to dyno calibration. We're not sure what happened there. Either way, I'm very pleased with the power!
Mods:
2jzgte (US spec)
K&N filter
RMM downpipe
HKS Super Dragger exhaust
Blitz boost controller
ADFX fmic
Here is the hp dyno sheet
https://www.clublexus.com/gallery/da...cn1087-med.jpg
I was also able to do a 1/4mile pull which is will say is VERY weird to do on a dyno, only because your inside of a shop and it just doesn't seem natural to get on the car as if you were at the strip. It was pretty cool though. Spinning 1st gear and part of second on the rollers, I really could have gotten a on it a bit harder . The top end doesn't seem to be the same as when my old supra was bpu+. I had to shift into 5th on the W58 and I just don't think the gearing is great for the 1/4. My trap was 113mph, when with a 6spd, it's probably going to be closer to 117 or so. Eitherway, it ran a 13.1 @113mph with a 2.35 60ft
Here is the 1/4 dyno sheet
https://www.clublexus.com/gallery/da...cn1089-med.jpg
Chris
93 SC300TT
#3
I also dyno-ed my car today. I did 20 pulls, all at 14psi. More realistic numbers this time ... before I had put down 511rwhp @ 15psi, but I also found it unbelievable since no one makes that power at that pressure, so ... today told the tale
My best run was 447rwhp @ 14psi and I believe torque was 440 ... but I haven't gone thru all the graphs yet. I have quite a problem at exactly 6,000 RPM, I am either getting a miss, detonation, or something, it dips pretty hard ... the AEM reads no knock over 1 volt, so I am hoping it is just a miss ...
Congrats on your numbers as well.
My best run was 447rwhp @ 14psi and I believe torque was 440 ... but I haven't gone thru all the graphs yet. I have quite a problem at exactly 6,000 RPM, I am either getting a miss, detonation, or something, it dips pretty hard ... the AEM reads no knock over 1 volt, so I am hoping it is just a miss ...
Congrats on your numbers as well.
#4
Lead Lap
Thread Starter
Thanks guys..
Angel, any idea where that 511 number came from? You still put down some amazing numbers though
congrats to you too! Hope you get that miss fixed.
Chris
Angel, any idea where that 511 number came from? You still put down some amazing numbers though
congrats to you too! Hope you get that miss fixed.
Chris
#5
I am sure that the 511rwhp came from the same place that my 489 run came from ... spike to 18psi. Now ... when I turn the boost up ... I am hoping to make 500+rwhp at 18psi and I see no reason why I shouldn't.
All of my dyno graphs are located here:
http://www.turboforum.net/lexus (just click on Dynos)
Here is my best graph of the day (in my opinion)
All of my dyno graphs are located here:
http://www.turboforum.net/lexus (just click on Dynos)
Here is my best graph of the day (in my opinion)
Trending Topics
#9
Bluegr*** Performance
Join Date: Feb 2002
Location: North Kentuckarolinay
Posts: 1,532
Likes: 0
Received 0 Likes
on
0 Posts
Nice - dyno day at SP? I hope to make it up to Chicago land in August to visit my family. I hope to stop out there. Maybe get the guys to tweak my set-up a little. Is there going to be an Elmhurst Toyota meet this summer again? I'd love to get up there for that if it is end of July or anytime in August. I'll let you guys know - maybe we can have get together.
#10
Lead Lap
Thread Starter
awj,
Yep this was the SP dyno day. $40 for 4 runs, hell of a deal
Curt is a good friend of mine, I'm positive he'll have another meet this year.
Not positive on any dates yet. We usually hang out every thursday night, and
there is a good chance, we'll move out meets to the new Elmhurst Toyota lot
You know to give me a ring if you're ever in town!
Chris
SC300TT
Yep this was the SP dyno day. $40 for 4 runs, hell of a deal
Curt is a good friend of mine, I'm positive he'll have another meet this year.
Not positive on any dates yet. We usually hang out every thursday night, and
there is a good chance, we'll move out meets to the new Elmhurst Toyota lot
You know to give me a ring if you're ever in town!
Chris
SC300TT
Thread
Thread Starter
Forum
Replies
Last Post
juanmedina
IS F (2008-2014)
21
03-30-16 04:20 AM