pjfernan

I just recently installed a Greddy MX SC300 exhaust on my 1996 SC400 with only minor modifications.
In order to make it fit, I have to cut the straight pipe out of the middle cat or resonator and weld the Greddy Y-pipe in place.
After that everything is just a straight bolt-on application.
There are some pictures in the CL Members Gallery.
Sorry, I could not attached them here.

Chris4.3

iTrader: (32)

Sounds good pjfernan,

I would love this setup just because the greddy sounds smooth and it looks great. Unfortunately, I am not cool with cutting the stock pipes up and welding. Maybe if you had pics available here to see how clean the setup came out to.

Toysoarer

lex400sc

pjfernan, I'm curious... doe your exhaust sound likes this: http://www.intellexual.net/movies/SC400_Greddy_MX.MPG ...or different?

VSsc400

iTrader: (1)

must be a california car because I don't have the cat thats pictured in your car.

AutoCoutureSC

iTrader: (8)

rich, i'll try and get some vids and sounds of my exhaust when turned on. i've been meaning to do it, but digi cam is OOS at the store...

pjfernan

Yes, the sound is the same as in the clip on intellexual.net.
I bought my system from Nopi after seeing the clip.
The car dyno 206.8hp with the Greddy exhaust and a KN cone filter.
204.7hp with the Greddy exhaust and the stock air filter.

AzLex

How big is the piping?

pjfernan

The piping is 60mm with a 115mm Muffler Tip.
The conversion will 2.36in. pipe diameter with 4.53in tip diameter.

Chris4.3

iTrader: (32)

pjfernan,

This may be odd but can take a picture of your exhaust to see how it was done? I'd like to mod the MX on my 400 as well.