A.C. parts replaced after compressor failed but still not fully cold
08-14-14, 03:10 PM
#1
Driver School Candidate
Thread Starter
Join Date: Mar 2013
Location: Louisiana
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
A.C. parts replaced after compressor failed but still not fully cold
95 SC300
Replaced compressor, condensor, dryer, expansion valve, and condendor. Had shop evac and load it with 2 pounds of r134a. My vent temperature is about 60 degrees. The expansion valve I installed came with an extremely long copper tube that attaches in the engine bay to the AC line. That tube was much longer than the stock valve. I am wondering if something like that could cause an issue or if I should look at something else.
Replaced compressor, condensor, dryer, expansion valve, and condendor. Had shop evac and load it with 2 pounds of r134a. My vent temperature is about 60 degrees. The expansion valve I installed came with an extremely long copper tube that attaches in the engine bay to the AC line. That tube was much longer than the stock valve. I am wondering if something like that could cause an issue or if I should look at something else.
Thread
Thread Starter
Forum
Replies
Last Post