Help with Power Steering Pump
08-06-14, 09:13 AM
#1
Driver School Candidate
Thread Starter
Join Date: Aug 2014
Location: AL
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Help with Power Steering Pump
I'm replacing the PS Pump on my 95 SC400 and while I was removing everything I got 3 of the bolts out but the top rear bolt is starting to strip and it's super tight. Any ideas on how to go at this thing before I completely destroy the bolt?
08-15-14, 03:58 PM
#2
Driver School Candidate
Join Date: Aug 2014
Location: Florida
Posts: 8
Likes: 0
Received 0 Likes
on
0 Posts
I removed top first so weight was not held by that bolt.
Opposite problem....same car....
Unit and reservoir out, but high pressure line remains attached. Can't break either at bottom cross member
or the 22mm nut on the unit. Suggestions?????
Opposite problem....same car....
Unit and reservoir out, but high pressure line remains attached. Can't break either at bottom cross member
or the 22mm nut on the unit. Suggestions?????
Thread
Thread Starter
Forum
Replies
Last Post
rome99LS
LS - 1st and 2nd Gen (1990-2000)
11
01-20-12 02:08 PM