ArkLaTexSC

I've come to the conclusion recently that I'm running lean. Although this also might have been affected by the oil change monkeys overfilling it last time. There is dieseling, there is pause directly after shifting at full throttle. Indications of running hot. Temp gauge reads normally however, and absolutely no loss of power. ECU was just rebuilt a week ago. Could this be a MAF issue? I've suspected it being bad for a little while now.

oldManTan

i had a CEL code 25 (running lean) changed the main O2 sensors on the headers, fixed that. do you have any codes? i doubt too much oil would cause this, just check the dip stick and drain some if there's too much.

ArkLaTexSC

I've got a CEL but it's a 93 so OBD1.

SC400slide

iTrader: (11)

All you need to do to pull the codes is grab a paper clip, short TE1 and E1, and count thenumber of blinks. For code 25, the CEL would blink twice, pause, than blink 5 more times. Then once you get your code, search it on the internet to see what it stands for.

ArkLaTexSC

Is there a diagram for those slots?

SC400slide

iTrader: (11)

Search function still available.

oldManTan

mine's OBD1 as well. here's all the codes and all the information you need to know for checking and reading CELs. sorry for the outside link

oldManTan

also when you open the cap for that plug there's a diagram inside it as well.

ArkLaTexSC

I got IAT (24) and MAF (31). Additionally, the OD was blinking rapidly.

ArkLaTexSC

The consensus of the internet on 24 and 31 is the MAF. Will go find a good one. Does the OD blinking mean anythig?

oldManTan

here's about the O/D light
https://www.clublexus.com/forums/sc-...-flashing.html

ArkLaTexSC

These guys all appear to have it flashing without OBD shorted. My tranny isn't acting odd except for a rumble if it auto-unlocks the torque converter via throttle in 4th gear. I try to avoid that.

oldManTan

oh so yours only flashes with diagnostics shorted?

ArkLaTexSC

Yup, that's right.

ArkLaTexSC

New junkyard MAF from an LS400 removed the CELs.