Help my sc took a **** on me
#1
Driver School Candidate
Thread Starter
Help my sc took a **** on me
I recently bought this 1995 sc300 about a month and half ago and little by little I've been replacing parts alternator , starter , battery , fuel filter ,so anyways yesterday night I put gas (93 octane) and as soon as I started the car it started misfiring a little bit . Then I drove for a minute or so with a steady throttle position and the rpm will drop for a second then pick up normally . I made it home with it misfiring abit. Now this morning it cranks and starts but immidiatly shuts off. Any suggestions? I pulled 3 codes 14 ignition signal , 25 lean a/f ratio,and 71 egr system malf. I've always had 71 but 14 and 25 are new
#4
Driver School Candidate
Thread Starter
Thanks for the reply , a code I've been getting this week since Saturday was code 14 failed ignition signal ... The Toyota handbook says it's one of 3 things ecu , harness , igniter . On Friday my car wouldn't start at all finally with no present cel while the key was in on position so I knew my ecu went bad . I popped open the ecu and 3 of 6 capacitors were leaking . I sent it to get rebuilt I hope all my problems stop now ! Sorry for the long reply !
#6
Driver School Candidate
Thread Starter
To Darryl in Georgia his phone number is (404)550-7511 he did a great job with my computer and only charges 150 compared to 250 everywhere else I checked .. He's quick too
Thread
Thread Starter
Forum
Replies
Last Post
ki_soarer
Performance & Maintenance
16
08-02-11 12:21 PM