na-t build aemv2 no start :( help!
05-20-14, 07:23 PM
#1
Driver School Candidate
Thread Starter
Join Date: Oct 2013
Location: Tx
Posts: 43
Likes: 0
Received 0 Likes
on
0 Posts
na-t build aemv2 no start :( help!
So i just finished my build. I load up start up calibration for the maf and it wont start.
Things i did
Pulled engine, took off head did head studs.and tt gasket. 550cc rx7 injectors, 340 fid pump, aem v2 blah blah.
Drop everything in.... everythings in right.
I have fuel pressure, pump primes, car cranks but doesnt start. Plugs are new, new dizzy rotor bc mine looked like ****. New igniter and new coil. Getting "weak" spark.
Timing.should.be good enough to start. Grounds i know of are 2 on lower runners. One on tranny. One on rear of motor to firewall. One from batter negative. Anyone got advice? This possibly just tuning/ syncing timing issue?
Things i did
Pulled engine, took off head did head studs.and tt gasket. 550cc rx7 injectors, 340 fid pump, aem v2 blah blah.
Drop everything in.... everythings in right.
I have fuel pressure, pump primes, car cranks but doesnt start. Plugs are new, new dizzy rotor bc mine looked like ****. New igniter and new coil. Getting "weak" spark.
Timing.should.be good enough to start. Grounds i know of are 2 on lower runners. One on tranny. One on rear of motor to firewall. One from batter negative. Anyone got advice? This possibly just tuning/ syncing timing issue?
Thread
Thread Starter
Forum
Replies
Last Post
lp_yang
LS - 1st and 2nd Gen (1990-2000)
3
09-26-06 06:46 AM