HOW TO: Tap Oil Pan for NA-T Turbo Return
08-29-18, 06:47 AM
#31
Yes, that is where the 17/64 drill bit comes into play. Take your studs, place them next to your drill bit, put tape around the drill bit where the bolt stops (That way you can tell how far to drill into the pan). Drill it straight and don't go past that tape!
The following users liked this post:
Ali SC3 (03-05-20)
Thread
Thread Starter
Forum
Replies
Last Post
Golden95SC
SC- 1st Gen (1992-2000)
12
05-31-15 07:34 PM
SC300_704
Performance & Maintenance
1
05-13-08 04:54 PM
