HOW TO: Replace center support bearing and remove driveshaft.
#17
Will this job be the exact same on a SC400? I'm not aware of the driveshaft/exhaust differences between the two.
Also, what size socket did you use to tap the new bearing on? I'd think you want it to fit the inner race, which is about 30mm, but it looks like you used a socket that fit the outer portion of the assembly, rather than the bearing itself.
Also, what size socket did you use to tap the new bearing on? I'd think you want it to fit the inner race, which is about 30mm, but it looks like you used a socket that fit the outer portion of the assembly, rather than the bearing itself.
Thread
Thread Starter
Forum
Replies
Last Post