Sc400 hesitates
#1
Driver School Candidate
Thread Starter
Join Date: Dec 2013
Location: arkansas
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
Sc400 hesitates
Hi all I have an issue with my sc400, I just recently fixed my vacuum leak but it still has some mild hesitation, my car is n need of a new intake but I have no clue where to get one since everyone tells me it is a dealer item and there isn't a dealer anywhere near me, but on the subject of the hesitation, it is only from a stand still and is only when the motor is warm, any advice anyone could give me would b great, it was sitting outside for a while and I am bringing it back to life, has 188k on it and it is the 1uz-fe
#3
Driver School Candidate
Thread Starter
Join Date: Dec 2013
Location: arkansas
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
I haven't done much, all I did was replace plugs and wires bc 1 wire was n pieces and I had to rig a valve n the intake for the vacuum stud that was broke off, after that it's exponentially better but still not 100 percent, I have a lot of things I have to do to it, but I wanna get it running right first, is there somewhere online that I could get a factory intake resonator for it? Or should I just go with a cold air intake and do away with it?
Thread
Thread Starter
Forum
Replies
Last Post