Map Ecu 1
#2
#3
Driver School Candidate
Thread Starter
I just don't want it to lean out. I guess with boost controller n A/F and I dont squeeze it to much I will be fine until I get the appropriate injectors to really utilize the turbo. I guess your right about a good tune. Just there so many turbos man.
#5
Lexus Test Driver
iTrader: (4)
^ this. Justin Nenni tuned an IS I put together with aristo swap and 6266 on a v2, customer went over budget and had to keep stock injectors. Car did like 390 on low boost. Make sure your gate spring is small. I believe I used a 7psi spring. Rule of thumb for boost controllers is you can usually only double what spring pressure is. its good to set a safety margin like this when not having adequate fuel system just in case the controller accidentally gets jacked with. You don't want base pressure being anywhere close to maxing your fuel system.
#6
Driver School Candidate
Thread Starter
Good looking out, I appreciate the input. I was able to find 550's in running condition and flow tested!! Shout out to Chase from North Carolina. I am a little upset my turbo connect didn't come through for me, but I was able to find a Garret 3071R with a 74mm precision inlet housing. I call it the Frankenstein. We shall see how it flows together.
Trending Topics
#9
Driver School Candidate
Thread Starter
Yea it's smaller then your average 1jz setup but response sppol,ball bearing, and good tuning hopefully will make it fun. What are you running megamax (Mr.Bigturboguy)
Thread
Thread Starter
Forum
Replies
Last Post
atl4love
GS - 1st Gen (1993-1997)
6
11-25-08 06:02 PM