2jzinsider

iTrader: (4)

I pretty much made a noob move and did not mark the cap when i removed them to install my hks 264's. I installed the intake side already and installed the caps the same way it came out but just the exhuast side i kinda got mind lost and im a little unsure. i'm pretty sure it's at its right location.








first 2


3rd and 4th

5th and 6th near the rear


can anyone here confrim that this is at the right direction and location of the cam caps? thanks

turbodremz

iTrader: (18)

If no one beats me to it, I can verify in a little while.

stockhatch

iTrader: (12)

Scrape all the sludge off of the top of the caps and you will find that they are all marked for location and direction. Use a soft wire brush since the stampings are pretty light.

turbodremz

iTrader: (18)

^^beat me to it. Check for the arrows in the center

blk&blu*j

iTrader: (1)

And just for your knowledge they get torqued to 14#s in sequence but do it after you go through the sequence and all are snug than torque.