TT upper mani Retrofit!?! almost done...
#1
Lead Lap
Thread Starter
iTrader: (6)
Join Date: Aug 2010
Location: CA
Posts: 434
Likes: 0
Received 0 Likes
on
0 Posts
TT upper mani Retrofit!?! almost done...
could not figure out my boost leak for months now and last night / today i ripped out the old intake manifold one my buddys made for me and i found it had a half mm crack that was like 11 inches long on the weld under the bottom side of the plenum! hurrah! i found it! maybe i can go past 7 psi now? haha
anyyywho... ive retrofitted a upper jdm tt mani to my lower GE runner i had some of the lower flange shaved down, then i port matched it and welded them together did most of the work so all i had to pay for was the mani itself 175$ with all the sensors, tb, and do dads
just gotta plug a few vaccum ports and redo the IC piping on the tb side its way off compared to my old mani
anyyywho... ive retrofitted a upper jdm tt mani to my lower GE runner i had some of the lower flange shaved down, then i port matched it and welded them together did most of the work so all i had to pay for was the mani itself 175$ with all the sensors, tb, and do dads
just gotta plug a few vaccum ports and redo the IC piping on the tb side its way off compared to my old mani
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
suprakidxx
Performance & Maintenance
10
01-23-14 09:59 AM
Jacj3
SC400 / 300 Classifieds
1
05-06-11 05:54 AM
Sc dRifta
SC400 / 300 Classifieds
17
01-14-08 03:51 PM