xspsi6

iTrader: (31)

I have been searching for 3 days now and all sort of lead to dead ends or unconfirmed theroys?
I read thet 2jz and 7m gaskets work with modifications but I would really like some that fit properly the 1st time

Any sources that carry them? Drift motion did not have anything either, I am just trying to fresh up a jdm motor that I am going to be installing in the near future.

DoomLight

iTrader: (3)

what exactly is needed to modify them? cause im looking to do my valve covers soon.

O. L. T.

iTrader: (17)

So.... this is the last thread we will be moving to the engine forum for you. Kinda looking at like ten of them in a month, lol. Take note

Biggu

iTrader: (12)

im using 2jz gaskets on mine, fit with out any modifications.

xspsi6

iTrader: (31)

Ok are gte and ge the same?

xspsi6

iTrader: (31)

It appears that they are indeed the same.

sayayin

iTrader: (2)

The 7mgte are direct fit for the 1jz I bought mine and are 18 plus tax.
Question for the new valve cover gaskets do I need to apply gasket maker?

Slow_Sc3

iTrader: (1)

2jz-gte valve cover gaskets fit without issue!

Vrank

iTrader: (4)

Mk3 supra and 88-92 Cressida. Both had 7m, turbo or non turbo doesn't matter since they were all pretty much the same pile of ****. Use some sealant in the front between the head and the gasket in the corners where the arch meets the flat surface. Pop the little half moon things off the back of the head and do fresh sealant there too.