1JZGTE swap into SC400
#1
1JZ Single SC400
Thread Starter
iTrader: (59)
Join Date: Jan 2009
Location: Alabama, Roll Tide!
Posts: 8,518
Likes: 0
Received 15 Likes
on
12 Posts
1JZGTE swap into SC400
I have a few detailed questions about my swap. I am currently doing the 1JZ swap and getting ready to build my power steering lines. I have deleted the intercooler for the rack already that is normally on the driver side by the bumper, so this is not in the loop, just the power steering rack, pump, and resevoir with lines.
My question is this the correct way to run the lines as shown below? Dont be laughing about my 5 minute drawing. If so, how long should the line in picture be cut to approx? I was thinking around 2 feet or so. That picture is from DM website. I will have to buy the correct fittings, but I want assure 100% the lines first. I cant find nothing on this at all.
I need some guidance on this...
My question is this the correct way to run the lines as shown below? Dont be laughing about my 5 minute drawing. If so, how long should the line in picture be cut to approx? I was thinking around 2 feet or so. That picture is from DM website. I will have to buy the correct fittings, but I want assure 100% the lines first. I cant find nothing on this at all.
I need some guidance on this...
#5
1JZ Single SC400
Thread Starter
iTrader: (59)
Join Date: Jan 2009
Location: Alabama, Roll Tide!
Posts: 8,518
Likes: 0
Received 15 Likes
on
12 Posts
The factory SC400 OEM power steering line worked for me like a champ. My build thread in signature shows the route I chose with the vacuum line hook ups.. Thanks for the replies.
Thread
Thread Starter
Forum
Replies
Last Post
myke441990
SC- 1st Gen (1992-2000)
4
06-15-11 06:23 PM