JDMSoarer5

I have a 92 SC300 and I'm planning on doing a w58 swap. I'm just wondering if the trans will bolt right up? Will I need all of the following parts?

soarer479

iTrader: (2)

dear god I hope your not paying that for all of that... some of those things arent needed. I didnt see anything about a drive shaft your going to need one of those, and lastly search because there are plenty of threads on this

JDMSoarer5

@ soarer479 - Thanks for your info, I was going back n forth about, if I really need all of those parts.

BAD954BOI

iTrader: (5)

all your going to need according to my knowledge is a w58 with bell housing, peddle conversion with master cylinder, Manual Shifter Boot, and manual drive shaft, and possible a clutch kit.

and i'm not positive about the ecu business but everything else should be legit