new to the game. driveshaft help please
#1
Driver
Thread Starter
iTrader: (10)
Join Date: Sep 2010
Location: sc
Posts: 163
Likes: 0
Received 0 Likes
on
0 Posts
new to the game. driveshaft help please
alright this is my issue well i guess its not a issuse since every 2jz swap has to do this.
anyways a buddy of mine is doing my 2jzgte swap in my 97sc300 before i leave to basic training. im trying to save him the time of figuring out what to do with the driveshaft. the pic below is what i have
is this all i need to have the driveshaft bolt up to the TT trans? i have read alot of people doing cutom DS or sc400 DS. can i just us the 3 bolt end and take put it on my sc300 DS?
anyways a buddy of mine is doing my 2jzgte swap in my 97sc300 before i leave to basic training. im trying to save him the time of figuring out what to do with the driveshaft. the pic below is what i have
is this all i need to have the driveshaft bolt up to the TT trans? i have read alot of people doing cutom DS or sc400 DS. can i just us the 3 bolt end and take put it on my sc300 DS?
#3
gte & na-t
iTrader: (44)
Join Date: Jan 2007
Location: Maryland /Germantown
Posts: 5,139
Likes: 0
Received 7 Likes
on
7 Posts
alright this is my issue well i guess its not a issuse since every 2jz swap has to do this.
anyways a buddy of mine is doing my 2jzgte swap in my 97sc300 before i leave to basic training. im trying to save him the time of figuring out what to do with the driveshaft. the pic below is what i have
is this all i need to have the driveshaft bolt up to the TT trans? i have read alot of people doing cutom DS or sc400 DS. can i just us the 3 bolt end and take put it on my sc300 DS?
anyways a buddy of mine is doing my 2jzgte swap in my 97sc300 before i leave to basic training. im trying to save him the time of figuring out what to do with the driveshaft. the pic below is what i have
is this all i need to have the driveshaft bolt up to the TT trans? i have read alot of people doing cutom DS or sc400 DS. can i just us the 3 bolt end and take put it on my sc300 DS?
#6
Not without mad fabbing/bearing skills. Even then I don't know if the lengths match.
All comments are correct about SC400 DS. You will also need the SC400 transmission output shaft + big honking 30mm socket (for auto if you're using an Aristo Trans).
Good luck in basic. What service you headed into?
All comments are correct about SC400 DS. You will also need the SC400 transmission output shaft + big honking 30mm socket (for auto if you're using an Aristo Trans).
Good luck in basic. What service you headed into?
Thread
Thread Starter
Forum
Replies
Last Post