Mk4 1.5jz project
#61
Lexus Champion
iTrader: (10)
With the seriousness of the build though I would have probably gone with a 2jz head by now.
Hope you guys have better luck this time around man
#62
gte & na-t
Thread Starter
iTrader: (44)
Join Date: Jan 2007
Location: Maryland /Germantown
Posts: 5,139
Likes: 0
Received 7 Likes
on
7 Posts
Hahaha Yes it is a tight fit !
But will get it done! We pulled the engine back out and pulled the head off and the block and head are both done , internals are done bent carillo rods and the pistions is also done.
So we got 10 CP pistions 8.5.1 with 0 miles on them 10 Carillo rods.
New block is going to the machine shop on Monday.. i will post some progress and the pics of the block and head
But will get it done! We pulled the engine back out and pulled the head off and the block and head are both done , internals are done bent carillo rods and the pistions is also done.
So we got 10 CP pistions 8.5.1 with 0 miles on them 10 Carillo rods.
New block is going to the machine shop on Monday.. i will post some progress and the pics of the block and head
#63
gte & na-t
Thread Starter
iTrader: (44)
Join Date: Jan 2007
Location: Maryland /Germantown
Posts: 5,139
Likes: 0
Received 7 Likes
on
7 Posts
Ali,
Na-t, 10.5.1 CR,CP pistons, Carillo HD rods, all the bells and whistle , Custums build intake maifold, and exhaust manifold from Freed Engineering and distributor hole will be shut close.
Na-t, 10.5.1 CR,CP pistons, Carillo HD rods, all the bells and whistle , Custums build intake maifold, and exhaust manifold from Freed Engineering and distributor hole will be shut close.
Thread
Thread Starter
Forum
Replies
Last Post
turbodremz
Build Threads
33
06-02-09 10:48 PM