GE motor with v160
#1
Pole Position
Thread Starter
Join Date: Jul 2006
Location: Florida
Posts: 252
Likes: 0
Received 0 Likes
on
0 Posts
GE motor with v160
I don't have enough money for motor and tranny and I'm in need of the tranny more so than the engine for now. Is it possible to mate GE motor to v160 to then swap in gte motor later? What would I need?
Trending Topics
#9
Driver
iTrader: (3)
Join Date: Apr 2010
Location: fl
Posts: 141
Likes: 0
Received 0 Likes
on
0 Posts
i know this is a old thread but can any one tell me if the slip yoke(parts slipsin tranny) for getrag is same as the tundra drive shaft ....and where i can find just the yoke so i can have a 3 1/2 inch custom drive shaft made
#10
Driver
iTrader: (3)
Join Date: Apr 2010
Location: fl
Posts: 141
Likes: 0
Received 0 Likes
on
0 Posts
i need some help i need build a drive shaft and dont want buy a six speed drive shaft to have to hack it up to get just the slip yoke ... (part goes in tranny)getrag tranny)six speed .im going build 3 1/2 inchdrive shaft and was told slip yoke is same as the tundra (is this true ) if not anyone know where i can get just the yoke .....i used search and came up with this thread...
Thread
Thread Starter
Forum
Replies
Last Post