Greddy/ trust jdm exhaust need piping advice
#1
Greddy/ trust jdm exhaust need piping advice
hey guys just got a dual exhaust made by greddy/ trust i believe off of a jdm soarer. got it from jhot but anyways the inlet piping is rusting through so i figured ill have my exhaust shop chop off the inlets but my question is what size to have them weld on.
im currently running a 3 inch catback flanged piping so i figure ill have them weld 3 inch inlets on these trust mufflers and put a y pipe from my 3 inch piping. im not an expert on backpressure and exhausts and all that but does this sound like a good idea?
any opinions on why or why i shouldnt do this? any and all opinions are appreciated
im currently running a 3 inch catback flanged piping so i figure ill have them weld 3 inch inlets on these trust mufflers and put a y pipe from my 3 inch piping. im not an expert on backpressure and exhausts and all that but does this sound like a good idea?
any opinions on why or why i shouldnt do this? any and all opinions are appreciated
Thread
Thread Starter
Forum
Replies
Last Post