GRN MNSTR

I was looking through the sticky thread, but most of the 400's were dual and the singles were either on 300's or boosted applications . I wanna run a single pipe so I was guessing about 2.5" should be good for the diameter but just wanted to get some other opinions as to if that's too big or too small. Any opinions are greatly appreciated. Thanks.

Edit: I have a 1UZ-FE VVT-i motor

- Pearce

OneJay

iTrader: (14)

If you're going single on a 1uz, I would go 3"

SH_JZZ30

iTrader: (1)

I agree on the 3" piping

GRN MNSTR

Ok so it's looking like 3" so far. Thanks for the input

rykwebb

3" fits perfectly from my 1JZ, hope it would do the same for you. 114mm tip Blitz yay.

GRN MNSTR

Nice...I got a 120mm tip HKS

Lexscme

wouldnt a 3" make it so raspy??? but unless u want the flow i guess 3" is ok i would go 2.75"

GRN MNSTR

Thanks for the input...I was considering that too...I just wish I had some more opinions

Lexscme

Sweet watch sum vids off youtube keyword sc400 exhaust their sum nice sounding ones.

GRN MNSTR

Yeah I have been. That's how I stumbled upon this...my new favorite youtube video lol:

http://www.youtube.com/watch?v=2Kmddi0-ZwU

QwkSC

iTrader: (1)

love that vid

GRN MNSTR

Well I got my HKS muffler and 3" piping done today and I must say I LOVE how it sounds. I would post a video clip but my uber cheap cell phone doesn't send pics or videos to e-mails, just phones. So if someone would be willing to accept a video sent to their phone and then upload it for me, I'd greatly appreciate it and would like to add it to the official exhaust thread


And Lexscme...it's not raspy at all...very deep with an agressive throaty sound on the throttle...I've yet to floor it cuz I don't drive it hard, but maybe one day. But it's not raspy which I'm very happy with.

ziptied

Who did you have do it?

v8soarer91

buick 3.8ltr usdm 2.5"
aussie commodore 3.8ltr 2.5"
aussie commodore 5.0ltr 3.0" or dual 2.25"
aussie commodore 5.7ltr 3.0" or dual 2.5"
aussie commodore 6.2ltr and 6.3ltr dual 2.5"
aussie ford falcon 4.0ltr NA 2.5" (even for the turbo models as a standard upgrade) XR6T and typhoon 2.5" or 3.0"
aussie for falcon 5.4ltr boss 3.0"
Mitsubushi magna 3.5ltr 2.25"

all listed are from a well known aussie performance exhaust manufacturer

GRN MNSTR

The Muffler Shop on Remount out here in North Charleston