checking codes
03-17-09, 11:51 AM
#1
Lexus Test Driver
Thread Starter
iTrader: (11)
Join Date: Apr 2005
Location: California
Posts: 911
Likes: 0
Received 0 Likes
on
0 Posts
checking codes
ok so i decided to check the ecu code and when i have the car to on position both engine and o/d light flashes... is this normal?
03-17-09, 12:15 PM
#2
Lexus Test Driver
Thread Starter
iTrader: (11)
Join Date: Apr 2005
Location: California
Posts: 911
Likes: 0
Received 0 Likes
on
0 Posts
ok if im only checking the engine light it gives me 3 flashes pause then 1... then i looked up the codes for obd1 it says
31 Air Flow Meter signal (Vacuum Sensor signal). where do i find this at?
31 Air Flow Meter signal (Vacuum Sensor signal). where do i find this at?
03-17-09, 07:29 PM
#4
Lexus Test Driver
Thread Starter
iTrader: (11)
Join Date: Apr 2005
Location: California
Posts: 911
Likes: 0
Received 0 Likes
on
0 Posts
omg thats what my is doing also i was going to make a video too. so have you found out what the prob was? for me i feel like the car is sluggish and doesnt want to get into gears... its not slipping though but just very slow responce... however i did replace both of my spark plugs and wires but still have this problem....
03-17-09, 08:56 PM
#5
Lexus Test Driver
iTrader: (3)
Join Date: Aug 2003
Location: California
Posts: 1,241
Likes: 0
Received 0 Likes
on
0 Posts
omg thats what my is doing also i was going to make a video too. so have you found out what the prob was? for me i feel like the car is sluggish and doesnt want to get into gears... its not slipping though but just very slow responce... however i did replace both of my spark plugs and wires but still have this problem....
)
Thread
Thread Starter
Forum
Replies
Last Post
AlaskanLS
LS - 1st and 2nd Gen (1990-2000)
6
08-09-18 09:52 PM
mrtentacle
LS - 1st and 2nd Gen (1990-2000)
3
01-26-07 04:49 PM
danreiner
LS - 1st and 2nd Gen (1990-2000)
2
01-07-05 09:00 PM
