RIP TimmyD

iTrader: (1)

I have a 1992 sc300 with a t66 turbo set up and i am looking to buy an exhaust for it. I just wondered if anyone could tell me what would be a good setup for what i have? I am looking for someting more on the throaty side. Thanks

TLDriver

iTrader: (4)

Make sure not only to look for brand but also size. Do a search.... a lot of us go custom piping to get the best of both worlds.

OneJay

iTrader: (14)

I would say 3.5-4" piping depending on how much boost you're running.

JspecSC3

iTrader: (4)

A decatted 4" would be great. A friend of mine ran that on his Supra when he had a 66 on an HKS muffler.

1985zcar

iTrader: (1)

I'm running a custom 3" catless/resonator less (basically straight pipe) with 2 3" polished tips, I run silencers for daily driving, it's still loud, but on the stock 1J sounds ****in radtacular.

Sizing would depend on how low you are. I'm low, and my exhaust hangs about 2 inches from the ground =/ If you're not that low and can fit bigger piping, it'd probably be better with that big of a turbo.

Biggu

iTrader: (12)

timmy, if you want to get hold of me/ pm me ill set you up with the shop that did my exhaust,

mine is a 4" to 3" duals and it sounds great!
www.youtube.com/watch?v=4fTWfDhOOlY

ScSlide

if you dont mind me asking.. how much did they charge to do your exhaust? what was the overall cost?




also i have a stcok 2jz ge

what mods need to be done in order to have a performance exhaust..i know that sounds like a dumb question...

and with it stock can i still have 3" to 4"?

Biggu

iTrader: (12)

my exhaust ran me around the ball park of 1100-1200

and a stock 2jz-ge with a 4 inch exhaust there is no way that would be needed, even a 3 inch people notice power looses with NA.

ScSlide

that is what i figured...

i just dont want to waste money on my exhaust if i plan on going na-t in the future

OneJay

iTrader: (14)

Mine is 3" to 2.5" duals and it ran me about 800 for everything including one magnaflow cat, resonator, y-pipe, and two mufflers. Its all mandrel bent too.

ucfa4

iTrader: (2)

I would get hks hi power full setup.

ScSlide

Could you just run 3" to 2.5" pipes all the way back with two mufflers??

OneJay

iTrader: (14)

Might be too small for his turbo setup.

ScSlide

what if you were just stock 2jz?

OneJay

iTrader: (14)

That would be good. Thats what I have right now. I had it on my stock motor for a year, and its been on my 1j for 6 months now. Sounds great!