sc300 swap
#1
Rookie
Thread Starter
iTrader: (2)
Join Date: Nov 2008
Location: FL
Posts: 77
Likes: 0
Received 0 Likes
on
0 Posts
sc300 swap
Hey guys, I know this topic has been discussed A LOT. I have spent countless hours searching for some answers, all I have gotten where guesses and unsure answer.
To get to the point. I have an sc300, I want to do a JDM 2jzgte swap (more than likely an aristo). I plan on using the usdm supra TT ecu and a supra harness. My questions are:
1) using the supra ecu, is it just plug and play to the engine? plug and play for the interior harness?
-I read somewhere that all I need to do is cut the engine plugs off the aristo and wire it to the usdm harness. (I don't know if that's true for sure)
2)Secondly could I just use the aristo 2jz on the stock auto tranny? or use the aristo tranny? with the aristo tranny I would have to change my driveshaft right?
Any help is appreciated.
Thanks
Also I already know all the other extras I have to get by using the usdm ecu.
To get to the point. I have an sc300, I want to do a JDM 2jzgte swap (more than likely an aristo). I plan on using the usdm supra TT ecu and a supra harness. My questions are:
1) using the supra ecu, is it just plug and play to the engine? plug and play for the interior harness?
-I read somewhere that all I need to do is cut the engine plugs off the aristo and wire it to the usdm harness. (I don't know if that's true for sure)
2)Secondly could I just use the aristo 2jz on the stock auto tranny? or use the aristo tranny? with the aristo tranny I would have to change my driveshaft right?
Any help is appreciated.
Thanks
Also I already know all the other extras I have to get by using the usdm ecu.
Last edited by sunrisetrd; 11-21-08 at 10:15 PM.
#2
Lexus Champion
iTrader: (4)
Join Date: Jan 2005
Location: N/A
Posts: 4,908
Likes: 0
Received 0 Likes
on
0 Posts
Welcome to the club. These topics have been discussed before but I'll go ahead and move this over to the SC300 Performance forum to better help you find what you are looking for. Goodluck!
Thread
Thread Starter
Forum
Replies
Last Post
slappy96
Performance & Maintenance
5
07-24-08 03:23 PM