breakb

iTrader: (2)

ok, when i'm trying to do a burnout. i just brake, and throw it into low gear, but my back end starts to like start shaking and stuff. is it supposed to do that? it starts around 3-4 rpm. is it just cuz it's not in the higher RPM's spinning faster and it's just gripping the ground? just want to know...

Peace out

scfocus

iTrader: (3)

wheel hop?

tuterz

iTrader: (11)

wheel hop?
as stated above.. im guessing maybe bad struts?

Kaydee

TRAC off?...

tcrow31

iTrader: (6)

Its wheel hop and if you keep slamming your trans like that you will toast it.

UTSC300

iTrader: (4)

haha thats funny. wait till your trans blows up next time. Then we can read a thread that starts like " Hey look at my toasted driveline". but please include pictures............

basically quit slamming your trans cause A : our cars are not made to do burnouts , the shaking and jerking is your car saying ouch. hope you havn't caused to much damage. Air freight on a sc400 trans isn't cheap to the islands.

turbodremz

iTrader: (18)

I dont think he's saying he's doing a "neutral bomb"..mabey he is..

but the back end shaking is wheel hop...welcome to rwd.

stop doing burnouts

Supra Dr

iTrader: (14)

Check all your rear suspension bushings carefully. The usual
culprit is the trailing arm bushings are beat. (the bar that
goes from the front of the wheel housing to the lower arm)