Boost controller install
#1
Boost controller install
Im sure this has been answer a million times bt i cantfind any info on it. Where do i install these vacuum lines. I know one has to go on the intercooler piping and the other two on the waste gate. I just dont know where to put them. One says to connect to wastegate actuator and the other says connect to a secondary port on wastegate actuator. Does our wastegate have a single or dual port actuator?
#2
Racer
iTrader: (16)
i asked this back then also, and i hooked mine up fine, but i totally forgot whut i did... i think i T'd the line off somewhere to split into both wastegate actuators.. FRONT AND REAR TURBO... took some elbow grease to get in there, and i beleive both lines from each actuator was T'd to my EBC solenoid... hope someone here can give u detailed info... it totally slips my mind on the install..
Thread
Thread Starter
Forum
Replies
Last Post
thegadget
Performance & Maintenance
13
06-17-09 03:54 PM