JJG2005

Ok, so I'm trying to hook up my charcoal canister and whatever is in that general area after removing to get access to the wiring harness for my 1JZ swap. Apparently I'm missing some vacuum lines or something and i can't figure out where they go. Can someone please post pictures of the charcoal canister, and/or the upper left part of the engine bay?

Thanks!!

5spdSC300

iTrader: (1)

Im intrested as well. I think i left one or two ports disconnected when i finished up my swap since i couldn't remember where they went.

CleanSC

You guys are pulling swaps without factory manuals?

All this info in is them with isometric diagrams and all.

Best hundred bucks you'll ever spend.

0l33l

iTrader: (3)

Why not just remove the charcoal canister

5spdSC300

iTrader: (1)

I did at first but it left a gas smell since the fuel tank vent goes through the charcoal canister.

PJ

I ran a hose from that back into my intake.

Durrr

if you let it sit for too long, the vapors could build up and possibly detonate in the intake

JJG2005

Warning!!! Danger To Manifold!!!!!11111!

Supra Dr

iTrader: (14)

DOH! Hope it doesnt ever backfire into the intake.

PJ

yeah good call... guess its time to think of a permanent solution

JJG2005

Hmm, I ended up keeping the canister, running the line from the gas tank to the canister, and them running only the purge return line back to the intake.