1jz swap started
#1
Lead Lap
Thread Starter
Join Date: Nov 2003
Location: Arkansas
Posts: 544
Likes: 0
Received 0 Likes
on
0 Posts
1jz swap started
Well I decided earlier this week to start my 1jz swap. I pretty much had everything their except for a few things that i'll have to wait to come in. Being that this was my first swap to perform, it seems pretty straight forward, although there's a few things i'm stumped on and can't figure out. Hoping some of the pros will help out?
1. While pulling the GE out we forgot to disconnect the steering sensor so the plug broke, i'll have to get a new one. There's also another small plug that sits on the steering rack but there doesn't seem to be a connector on the 1jz harness to plug into it. ??
2. On this water hose that runs from the back of the motor and pops out the intake side, where does it connect to? Does it need to be rerouted and connect on the opposite side?
1. While pulling the GE out we forgot to disconnect the steering sensor so the plug broke, i'll have to get a new one. There's also another small plug that sits on the steering rack but there doesn't seem to be a connector on the 1jz harness to plug into it. ??
2. On this water hose that runs from the back of the motor and pops out the intake side, where does it connect to? Does it need to be rerouted and connect on the opposite side?
#7
Lead Lap
Thread Starter
Join Date: Nov 2003
Location: Arkansas
Posts: 544
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by VJ RC51
thats your heater hose.....
and the little white plug for the power steering is on the passenger side of the motor.
and the little white plug for the power steering is on the passenger side of the motor.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
9secCivic
Performance & Maintenance
1
01-05-08 02:23 PM