kietlander

i just bought a RAZO RA108 shift ****.


i opened the box, and it looks amazing. when i go to put it on.....it doesnt fit. the threaded top is the right size. but the shaft gets wider about 1/3 the way down. now i have a brand new shift **** that doesnt fit... what should i do? MAKE it fit, cut and repaint. or just sell it on ebay.

SoarerJzz3

Yeah it does look nice, too bad it didn't fit. If you can make it fit without looking ghetto then do it.

kietlander

i think ill take a uni-bit to it and see what happenes....

jacques

You could possible use a tap to widen the threads of the **** if the difference isn't too large, either than that sell it on ebay.

kietlander

no i thinkk ill get ashort shifter. makes life easier.