sc300 distributor install
#1
Rookie
Thread Starter
Join Date: Jun 2003
Location: Virginia
Posts: 94
Likes: 0
Received 0 Likes
on
0 Posts
sc300 distributor install
Putting the distributor back in, do I line up the notches on the distributor and then slide it in (so when it's fully meshed with the cam the notches are no longer lined up) or do I turn it back a bit so that when it twists while sliding in the notches are lined up when completely meshed with the cam?
Hope that makes sense, thanks in adavnce, Marshall
Hope that makes sense, thanks in adavnce, Marshall
#2
Rookie
Thread Starter
Join Date: Jun 2003
Location: Virginia
Posts: 94
Likes: 0
Received 0 Likes
on
0 Posts
Well, since the engine started and ign timing is good, appearently you're supposed to line up the marks and then slide the distributor in. Hopefully this will help the next person who searches..
#4
Pole Position
iTrader: (1)
Join Date: Aug 2007
Location: California
Posts: 378
Likes: 0
Received 0 Likes
on
0 Posts
but if i marked my lines i wouldve done it in 15 minutes guaranteed
Thread
Thread Starter
Forum
Replies
Last Post
sc2chainz
Performance & Maintenance
2
10-26-12 10:46 PM
ISFFUN
SC- 1st Gen (1992-2000)
12
01-27-11 01:22 PM
300, 93, 94, club, clublexus, distributer, distributor, gs, gs300, install, installation, lexus, position, sc300, timing