CA FS: 1996 GMC Sierra K1500 Z71, lift, mods, etc.
#1
FS: 1996 GMC Sierra K1500 Z71, lift, mods, etc.
Asking $6500/obo.
I have the title in hand, ready to sell. I bought this truck a few months ago with the intent of fixing it up and keeping it for a while. Plans have changed, but ive fixed damn near everything on the truck.
1996 GMC Sierra K1500 Z71, 170xxx miles. Color is blue. Truck has the factory 10 bolt rear end with 3.42's. I have replaced every part i could find that was bad or needed attention. I have only driven the truck less than 2k miles since purchase. Everything works...
I have replaced the following within the past 1-2k miles, some within 500 miles....
Eclipse single din flip out nav unit
Infinity front door speakers
Flowmaster exhaust, dual in, dual out, dumped at axle
Pacesetter CARB legal headers
Magnaflow cats and y-pipe.
Driver side inner and outer door handles
HID low beams and silverstar high beams
New parking light lenses
All filters and fluids have been replaced
New front diff actuator assy
Superswamper Radial SSR 35x12.5-16.5 (cost over 1300!)
Procomp RS9000 shocks
New 145amp alternator, idler, and belt
New A/C compressor
New brake master cylinder
New wiper motor control board
Replaced door pins and bushings on both doors
New billet distributor, cap, rotor, wires, iridium plugs, Accel coil
New 180 degree thermostat, temp sender, coolant flush
New Optima yellow top battery, extra ground and power cables
K&N FIPK intake kit
Hypertech tuner for tires, speedo, shift firmness, etc..
New bulbs in the cluster and climate controls
Ported throttle body
New front rotors, pads, wheel bearings, abs sensor
Toolbox on truck bed
Tinted tail lights and 3rd brake light
I am probably missing things, as i cant remember it all right now. But basically the truck is damn near in 100% condition.. there are a few items that could be fixed, but arent essential to operation...
Cons: vibration at freeway speeds, have balanced the tires, its not huge, but definately there, has to be expected from a big truck like this. passenger front seat doesnt slide unless you recline it first. temp gauge inside doesnt go to normal position, but have verified proper temp with scanner. truck has a pull to the right, but it isnt huge.
I also have a new front air dam made for factory fog lights, which i have, with an HID kit for the fogs. Also have poly sway bar bushings, control arm bushings, transfer case output shaft seal, front ball joints, and maybe more to include if i get my asking price.
Please PM or email me any questions... RTCamaroSS@aol.com
Links to the pictures since they are huge pictures....
http://home.comcast.net/~rtornio/Images/DSC02531.JPG
http://home.comcast.net/~rtornio/Images/DSC02532.JPG
I have the title in hand, ready to sell. I bought this truck a few months ago with the intent of fixing it up and keeping it for a while. Plans have changed, but ive fixed damn near everything on the truck.
1996 GMC Sierra K1500 Z71, 170xxx miles. Color is blue. Truck has the factory 10 bolt rear end with 3.42's. I have replaced every part i could find that was bad or needed attention. I have only driven the truck less than 2k miles since purchase. Everything works...
I have replaced the following within the past 1-2k miles, some within 500 miles....
Eclipse single din flip out nav unit
Infinity front door speakers
Flowmaster exhaust, dual in, dual out, dumped at axle
Pacesetter CARB legal headers
Magnaflow cats and y-pipe.
Driver side inner and outer door handles
HID low beams and silverstar high beams
New parking light lenses
All filters and fluids have been replaced
New front diff actuator assy
Superswamper Radial SSR 35x12.5-16.5 (cost over 1300!)
Procomp RS9000 shocks
New 145amp alternator, idler, and belt
New A/C compressor
New brake master cylinder
New wiper motor control board
Replaced door pins and bushings on both doors
New billet distributor, cap, rotor, wires, iridium plugs, Accel coil
New 180 degree thermostat, temp sender, coolant flush
New Optima yellow top battery, extra ground and power cables
K&N FIPK intake kit
Hypertech tuner for tires, speedo, shift firmness, etc..
New bulbs in the cluster and climate controls
Ported throttle body
New front rotors, pads, wheel bearings, abs sensor
Toolbox on truck bed
Tinted tail lights and 3rd brake light
I am probably missing things, as i cant remember it all right now. But basically the truck is damn near in 100% condition.. there are a few items that could be fixed, but arent essential to operation...
Cons: vibration at freeway speeds, have balanced the tires, its not huge, but definately there, has to be expected from a big truck like this. passenger front seat doesnt slide unless you recline it first. temp gauge inside doesnt go to normal position, but have verified proper temp with scanner. truck has a pull to the right, but it isnt huge.
I also have a new front air dam made for factory fog lights, which i have, with an HID kit for the fogs. Also have poly sway bar bushings, control arm bushings, transfer case output shaft seal, front ball joints, and maybe more to include if i get my asking price.
Please PM or email me any questions... RTCamaroSS@aol.com
Links to the pictures since they are huge pictures....
http://home.comcast.net/~rtornio/Images/DSC02531.JPG
http://home.comcast.net/~rtornio/Images/DSC02532.JPG
Thread
Thread Starter
Forum
Replies
Last Post
jpvarghese
SC- 1st Gen (1992-2000)
21
07-26-13 10:51 PM
RTIS250
NON-Lexus vehicles for sale
0
01-12-10 08:37 PM
nysupraman
Lexus Vehicles Classifieds
15
03-21-09 10:04 PM