Left back seat under cover trim, how to removal
#1
Pole Position
Thread Starter
Left back seat under cover trim, how to removal
Hello everyone, I'm Vince just picked up a 2004 lx470 with 70k miles blizzard white, been a long time lurker now finally found the right lx470. Can anyone point me on how to removed the undercover trim of the left back seat, I want to access it becoz the PO put in a DVD player not working now, and now I need to remove it, but it seems the only way to access is to removed the plastic undercover trim, I looked and searched and can't figure how. It's that bottom plastic trim you see when you fold up the left rear seat. Thanks everyone looking forward to being part of the club.
Last edited by anesthesia; 04-04-16 at 08:33 AM. Reason: Forgot pic.
#2
Driver School Candidate
If you remove the 4 14mm bolts that hold it to the floor, you can slide it to the back of the rig, set it upside down, (I did mine on my tail-gate) and then just remove the screws that hold it to the frame. I had to replace a seat belt buckle and had to remove my bottom cover.
Found a lot of kids toys and some money under mine from the previous owner!!
Found a lot of kids toys and some money under mine from the previous owner!!
#3
Pole Position
Thread Starter
If you remove the 4 14mm bolts that hold it to the floor, you can slide it to the back of the rig, set it upside down, (I did mine on my tail-gate) and then just remove the screws that hold it to the frame. I had to replace a seat belt buckle and had to remove my bottom cover.
Found a lot of kids toys and some money under mine from the previous owner!!
Found a lot of kids toys and some money under mine from the previous owner!!
#4
Driver School Candidate
It makes it easier to reach the screws on the bottom front. It's really not that difficult, just remove the 4 14mm bolts on the hinges and lift up on the seat and it comes off. I just flopped mine down and slid it to the back of the truck to use the tail gate as a workbench.
#5
Pole Position
Thread Starter
Ha! Yes, there was a lot of kid stuff! After washing the dollar bill I found, I bought a $1.00 lottery scratcher and won $20!!
It makes it easier to reach the screws on the bottom front. It's really not that difficult, just remove the 4 14mm bolts on the hinges and lift up on the seat and it comes off. I just flopped mine down and slid it to the back of the truck to use the tail gate as a workbench.
It makes it easier to reach the screws on the bottom front. It's really not that difficult, just remove the 4 14mm bolts on the hinges and lift up on the seat and it comes off. I just flopped mine down and slid it to the back of the truck to use the tail gate as a workbench.
Vince
Thread
Thread Starter
Forum
Replies
Last Post
rfopt
ES - 5th Gen (2007-2012)
3
04-05-19 07:32 PM