WA Fs: Ucf10/20 nrca
#1
Pole Position
Thread Starter
iTrader: (5)
Join Date: Aug 2009
Location: WA
Posts: 332
Likes: 0
Received 0 Likes
on
0 Posts
Fs: Ucf10/20 nrca
Pictures of them installed on his car.
I maxed my front camber out at -5.5 on 19s with these. My car has poke in the front so I'm sure I could get a few more degrees out with more lowering.
The they are made out of 6061-T6 Aluminum and the hardware used is 12.9 grade. They also lower the car 1.25 inches in addition to adding almost another inch of coil-over travel.
150 shipped. Text me at 425 736 8649 for the fastest response.
Last edited by S30ZG; 07-20-11 at 09:04 PM.
#6
These rca's raise the car because it moves the knuckle up 1.25" from the control arm. It then spaces the knuckle outward to add camber. These lower any ucf10/20 with any type of suspension.
#7
so lets say i got a nice drop but def would love to see an extra 1" without having to cut my springs i could just get some of these made 1"? and also you say it add camber. i believe for alignment mine is maxed out will this affect allignment to the point where the car will never be aligned correctly?
Thread
Thread Starter
Forum
Replies
Last Post
DiezDos
4Gen GS450H / 350 / 300 / GS-F Classifieds (13-)
1
12-19-17 03:02 PM
Crew
3Gen IS250 / IS350 Classifieds (14-)
3
06-12-17 06:23 AM
shocker2
1Gen RC350 / RC-F Classifieds
1
12-08-16 06:17 AM