pl3wis

iTrader: (1)

I'm gonna throw on my viennas on my Ucf10. What's a good brand of lug nuts to use??

timmy0tool

iTrader: (7)

any short open ended tapered-seat 12x1.5mm lugs will fit. OEM lugs will not fit as they are mag-seat. it needs to be short and open ended so they clear the center caps .

PureDrifter

iTrader: (10)

Muteki's are cheap and work

Project Kik's are expensive and work.
Rays and Work also make lugs.

timmy0tool

iTrader: (7)

even the short mutekis might be too tall for the center cap. it depends on the type of disk face your wheels are.

on my viennas, the fronts are HI disk so the lugs will sink in, but the rear is LO disk and the lugs will stick out and interfere with the center cap if too tall.

Dubbayoo

I like those SSR Viennas a lot. I think I'm down to those, Leon Hardiritt Ritter or the Work VS Dish.

Dubbayoo

How short do these need to be? I see 48mm, 35mm and 21mm.

timmy0tool

iTrader: (7)

48mm and 35mm are too long. don't get muteki! just get general open ended nuts like the one pictured.