Scrape Pan anyone?
#1
Pole Position
Thread Starter
iTrader: (5)
Join Date: Aug 2009
Location: WA
Posts: 332
Likes: 0
Received 0 Likes
on
0 Posts
Scrape Pan anyone?
I was wondering if any static or bagged LS4 owners have fabbed up a scrape pan of sorts to protect ones oil pan because of the lack of ground clearance? The oil pan doesn't sit super low on my ucf10 but i would like to have something there just in case because i already have a few gouges from the the terrible roads of Downtown Seattle. In addition to that i also plan on going a tiny bit lower in the front and since I'm at static ride height i can't exactly raise my car up when i see a speed bump or some irregularity in the road.
#2
BahHumBug
iTrader: (10)
i scrape mine but don't have it TOO bad right now, my exhaust+frame though is getting scraped up pretty bad.
provided you use the front crossmember as the mounting point and a reasonably strong piece of steel (3/8"?) you should be fine.
i was even considering using some starboard or UMHW so it slides easier...
provided you use the front crossmember as the mounting point and a reasonably strong piece of steel (3/8"?) you should be fine.
i was even considering using some starboard or UMHW so it slides easier...
Thread
Thread Starter
Forum
Replies
Last Post
sha4000
LS - 1st and 2nd Gen (1990-2000)
4
01-13-13 07:04 AM