topgun129

Hi Folks,

I'm kinda at a loss here as to why after changing the thermostat and coolant temp. sensor the car started making a wierd wizzing noise after the car was running for about 5 minutes. It started fine.

As soon as I heard the noise I immediately turned off the car.

A few things...

When I pulled the hose to get to the thermostat and when I pulled the thermostat out I lost coolant, but did add some before starting the car (but I'll admit not as much as I lost). As of right now the resevoir is sitting empty. And coolant is leaking from the thermostat housing. I think I'll need that paper filter thing.

When I did the sensor I had to remove a lot of part to get to it (just like doing a tune-up kind of) but I did put everything back the way it should be.

Any ideas? Luckily I didn't see any smoke or anything dangerous happen, but I am worried that nothing serious occured due to that wizzing noise.

Thanks for your input!

etex

I think I would begin by adding the correct amount of the proper coolant....

PureDrifter

iTrader: (10)

air bubble

willhickey

iTrader: (1)

fix that leak!!!!! if not its going to keep getting air etc.