dash is seperated
#1
Driver School Candidate
Thread Starter
Join Date: Mar 2008
Location: oklahoma
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
dash is seperated
I need help and please be nice. The center of my dash right above my ac vent has bubbled up and I cant get it to stay down. Does anyone know how to fix it???
#6
Intermediate
I've seen my dad fix these on the Toyota Crown before.
It was one of these, lifted on the upper lip.
Essentially you need to make it accessible (remove the vent) and apply a healthy serving of contact cement (available most hardwares and even walmart). Allow it to dry completely on both surfaces (as per instructions).
Most importantly, when putting the surfaces into contact to actually stick them together you need to use something to physically hold them together. A good old pair of locking pliers with a piece of wood or something to blunt the contact point will do nicely.
Once the cement sets you're good to go.
Check out the Crown here. Amazing machine. A lot of it the basis for our 1st gen LS400's. The one my dad owned actually had a 1uz-fe in it.
I'd still like to see if I could get this to go into my LS.
It was one of these, lifted on the upper lip.
Essentially you need to make it accessible (remove the vent) and apply a healthy serving of contact cement (available most hardwares and even walmart). Allow it to dry completely on both surfaces (as per instructions).
Most importantly, when putting the surfaces into contact to actually stick them together you need to use something to physically hold them together. A good old pair of locking pliers with a piece of wood or something to blunt the contact point will do nicely.
Once the cement sets you're good to go.
Check out the Crown here. Amazing machine. A lot of it the basis for our 1st gen LS400's. The one my dad owned actually had a 1uz-fe in it.
I'd still like to see if I could get this to go into my LS.
Last edited by dfkd; 07-20-08 at 06:02 PM.