healerhand

Hey Gang,

I have installed Phillips HID conversion. I love it, but there is not High beam. Few weeks ago i accidentally turned on my high beam and my head light fuse broke. I was driving without head light for a few minutes and its dangerous.

I would like to know if anyone know where i can find my High beam wire so i can us a cut-off switch.

I tried to look for it in the Fuse box (right next to the battery), but no such luck for high beam. Only headlight fuse. Any suggestions?

LOTC

Check the fuse box under the drivers side,under the steering wheel.Did you find the broken fuse yet? If not I would pull about every fuse and look for the broken one. The LS manual should show which fuses are for which component.

Man David if its that dangerous I might think twice before I get a HID kit.

healerhand

Its nice, but you have to be very careful when u make a turn signal. Accidentally high beam will burn the head light fuse. That is why i want to take out the high beam wire.

Christian

Get the european high beams. Here we have the high beams where you have the fog lights. We got our fog lights in the bumper. We also have an extra spoiler at the bumper.