johnnyg66

So i bought all four uppers from rockauto and finally put them in this week. Cost just $190.00 shipped. I did some research and felt they would be a good alternative.

All in all took me about 3 hours to replace them i might do the lowers sometime and they should cost around $300. The build quality is very close to OEM only exception is the ball joint pin is a bit longer than oem and the boot cover is different but it does not make a difference. The ride quality for me has been very good. I did notice a difference from what i had the bushings i had had some cracks and the ball joint had more play in them.

For the price you can't beat these as an option. One of the pictures i posted shows OEM and MAS side by side installed. I had to stop and come back to finish that side another day.

leonrojo18

Ha! I bought eight of them yesterday, glad they worked out.

johnnyg66

Nice! You have to take photos of the lowers when you install them.

leonrojo18

Ok, I'll ask my mechanic. Is the ride still smooth/luxury?

johnnyg66

Yes, even better because i was getting some small thumps. Drove over same roads and no nothing. I will have to recheck my lowers and see if i need to do those too.

leonrojo18

glad to hear, can't wait to get them on. All of mine were gone

drew05

just replaced all 8 of mine with mevotech. couldn't be happier.

Doublebase

I used a mixture of Mevotech and Beck Arnley...25,000 miles later and so far so good.

leonrojo18

Put my mas arms in, all eight oem arms were shot. Also did oem struts. Car drives great except for a vibration that was there before. At tire shop now.

johnnyg66

Nice. Did you get any shots of the old ones?

2v1g

how do you do the alignment yourself after struts change?

johnnyg66

I was wondering where this product went and found out Doorman bought them out in 2017.