Tie rod ends
#1
Driver
Thread Starter
Tie rod ends
Hey guys,
Can tie rod ends be replaced without taking off the rotor and brake dust shield? If I remember correctly it looked pretty snug with the shield. Thanks and have a great week.
Can tie rod ends be replaced without taking off the rotor and brake dust shield? If I remember correctly it looked pretty snug with the shield. Thanks and have a great week.
#4
Yes, they can
FWIW, I did a little DIY write up here
https://www.clublexus.com/forums/ls-...-rods-diy.html
I will say though that it's probably a good idea to NOT get ones that have grease nipples because you can't get good access once installed. So I would find one that is a sealed unit. If I could do it again, that's what I would do (even though I really like Moog's Problem Solver line)
FWIW, I did a little DIY write up here
https://www.clublexus.com/forums/ls-...-rods-diy.html
I will say though that it's probably a good idea to NOT get ones that have grease nipples because you can't get good access once installed. So I would find one that is a sealed unit. If I could do it again, that's what I would do (even though I really like Moog's Problem Solver line)
The following users liked this post:
LexRex (07-16-21)
#5
Driver School Candidate
Join Date: Jul 2021
Location: Hi
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Backwards tie rods?
My mechanic friend is replacing my front passenger side cv axle. Upon examination he observed that the outer tow rod end on the front passenger side has an L marking. Are my tie rods on the wrong sides?
Thanks!
Jill
Thanks!
Jill
Thread
Thread Starter
Forum
Replies
Last Post
Horsepwr
LS - 1st and 2nd Gen (1990-2000)
3
03-05-10 09:10 PM
400 Degrez
Suspension and Brakes
19
01-02-07 01:34 PM