Rear shots - Show your Exhaust tips
#23
4.5" O.D., slant cut and 18" long when I bought them, they were cut down and welded to the SS Magnaflows, probably 12-14" long now. They stick out about 2.5"-3" from the bumper.
#25
some of these pictures i just snapped for this since i am at work.
i had PPE build my exhaust. its 2 1/4" stainless from the cat back. into a magnaflow x muffler in the middle and 2 more magnaflow mufflers at the end (one on each side), finished off with magnaflow tips.
i also have ppe headers.
i had PPE build my exhaust. its 2 1/4" stainless from the cat back. into a magnaflow x muffler in the middle and 2 more magnaflow mufflers at the end (one on each side), finished off with magnaflow tips.
i also have ppe headers.
Last edited by User 82021; 08-19-21 at 01:10 PM.
#26
#27
some of these pictures i just snapped for this since i am at work.
i had PPE build my exhaust. its 2 1/4" stainless from the cat back. into a magnaflow x muffler in the middle and 2 more magnaflow mufflers at the end (one on each side), finished off with magnaflow tips.
i also have ppe headers.
i had PPE build my exhaust. its 2 1/4" stainless from the cat back. into a magnaflow x muffler in the middle and 2 more magnaflow mufflers at the end (one on each side), finished off with magnaflow tips.
i also have ppe headers.
You have the exact set up I have been thinking of having done. Can you share any tips or advice for this set up and install? Did you reuse your factory cats with the ppe headers? Factory header bolts and gaskets? Any leaks at flanges or check engine light issues? Very interested to hear what you have to say. Thanks
#28
You have the exact set up I have been thinking of having done. Can you share any tips or advice for this set up and install? Did you reuse your factory cats with the ppe headers? Factory header bolts and gaskets? Any leaks at flanges or check engine light issues? Very interested to hear what you have to say. Thanks
as far as the cat back exhaust it was a one-off that ppe did. its one of the benefits of living in the same town as them. i also had them do a one off intake. all of these mods woke the car up.
the noise is pleasant unless you stand on it, then you can definitely hear it, as well as most cars around you. it has a very exotic sound to it.
i hope this helps.
#30
Lexus Fanatic
iTrader: (1)
Did you happen to dyno your car azcamber? Any realistic idea on hp / tq gain? Looks really nice! I thought 20 HP was what was quoted by others. On my old Mustang GT with a JLT 2 CAI, SCT 2 Evo tune, LT Kooks headers, X-pipe, High-flow cats, and Borla S-type equaled 82 HP. But not being able to tune a LS430 is a major downfall.
Last edited by Lavrishevo; 05-05-14 at 02:26 PM.